Denna rapport har sitt ursprung i det kodefaktoriseringsarbete som utfärdats våren 2013 som examensarbete i dataingenjörsprogrammet vid Örebro Universitet. Arbetet utfärdades på Nethouse i Örebro, och hade stort fokus på koddesign och kodkvalitet.I rapporten diskuteras vilka faktorer som påverkar hur underhållbar och läsbar en kod är, men också hur man på ett rimligt sätt kan utvärdera och mäta kodkvalitet.Den teoretiska biten blandas med den praktiska, där läsaren introduceras för ett flertal metoder, och hur dessa sedan implementerades i det faktiska projektet som Nethouse tillhandahöll..

Propofol is an intravenously administered, hypnotic and short- acting pharmaceutical. One common sideeffect (>1:10) and therefore a disadvantage with propofol is the local pain that arise when the initial injection is given. Why the pain arise is not clearly understood. A majority of different pharmacological treatments, different doses and combinations, alternative administrations methods and physical interventions have been tried to reduce the pain when injection of propofol is given. One important task for the nurse is to relieve pain for patients.

In this study the opioid buprenorphine was given to 8 clinically healthy goats. The pharmacokinetics and behavioral effects were studied. Injections of buprenorphine, 0.02 mg/kg body weight was given both intramuscularly (i.m.) and intravenously (i.v.) with a cross over design. The results showed a short half-life of the drug in the plasma, 65.9 ± 17.4 min (mean ± SD), after i.v. injection.

In veterinary medicine, penicillin is the most used antibiotic in Sweden. Two dosage forms of penicillin are available in Sweden for use in horses, sodium benzylpenicillin (Na-pc) and procaine benzylpenicillin (proc-pc). Proc-pc is the most used dosage form and is used for intramuscular administration which allows horse owners to treat an animal at home under veterinary instruction. Na-pc is only approved for intravenous use in horses. Penicillin is normally well tolerated by horses but a serious, sometimes life-threatening, adverse reaction called penicillin shock may occur.

Intramuscular injections to cats can generate strong reactions in some individuals while reactions of the same extent, according to the author, not always are recognized when using the subcutaneous route. The reactions are probably caused by fear, stress and/or pain. When the injection can generate pain one has to take that into account, which can be a limitation in treatment. It is well known that injections generate pain, but knowledge about the cause and processes of the injection-associated pain is limited. This is mainly due to the difficulty in finding objects to study pain on, high cost of use of laboratory animals and difficulty to obtain objective measurements. Although there is evidence that there may be a local muscle injury by intramuscular injection, it is not always that the extent of damage is related to the pain experienced. Facts about the causes of injection-associated pain have been studied in a literature review.

The work covered in this report includes a literature study of the diesel dual fuel technology(hereinafter referred to as DDF). The literature study covers earlier work that has been doneregarding the use of compressed natural gas (CNG) and diesel in a DDF system. Moreover a onecylinder research diesel engine was fitted with a CNG fuel system for experimental testing. Theinstallation of the engine and the test cell is described. Results from the tests are presentedcovering emissions, heat release and pressure traces from the DDF-concept.During the literature study it was found that most research was related to heavy duty dieselengines.

A one-cylinder research engine has been used for studies with a Diesel Dual Fuel concept (DDF). DDF is a concept that utilizes a pilot diesel injection to ignite a homogenous natural gas/air mixture. Emissions and engine efficiency have been analyzed in an emission cycle called European Stationary Cycle (ESC) and the knock/pre-ignition problems with this type of engine have been investigated.At low and mid torque levels, an early diesel injection around 60 crank angles degrees (CAD) before top dead center (TDC) was used. At these loads raw NOxemissions was below EURO 6 level (0.2 g/kWh). NOxwas at EURO 5 level over the complete ESC without after treatment and with SCR at high loads it should be possible to reach EURO 6.One issue with DDF is the high HC emission levels.

The aim of this thesis is to improve the control of urea injection at the combined power and heating plant Framtidens Gärstad (FTG). Tekniska Verken i Linköping AB is the owner of the plant.The FTG plant consists of a boiler where garbage combustion is done. From the combustion nitrogen oxides are emitted. These nitrogen oxides are hazardous to the environment. To reduce the nitrogen oxides, injection of urea into the boiler is used.

This thesis describes redesign and adaption of a products housing. In order to make it more economical to produce at a lower production volume. The thesis is based upon a prototype that a previous student developed for injection moulding. The goal is to find alternative manufacturing methods, but also to identify parameters that affect the cost of the injection moulding tool.The housing must be tough in order to protect the circuit board inside. But at the same time it must allow sound, light an electrical communication to pass through.

The ammonia emissions are an environmental issue since they contribute to eutrophication. By far the largest source of ammonia emissions is manure from agriculture and should therefore be reduced. Loss of ammonia is not only negative for the environment but also to the farmer who loses nitrogen that could have been used by the crop. The focus of this study has been emissions from spreading slurry where the loss can vary widely depending on slurry-, soil-, and weather conditions. There are mainly two different ways to reduce the emissions. One is to inject or mix the slurry into the ground to avoid air contact. The other way is to use acid to reduce the pH in the slurry to a level between 5 and 6 where the equilibrium is so strongly pushed to NH4+ that hardly any NH3 can be lost.

Methadone is frequently used as an analgesic drug for dogs although there are very few studies describing the pharmacokinetics of methadone in this species. In man methadone has a long half-life and there are considerable differences in pharmacokinetics between individuals. The dose interval is lengthened when the drug is used fore longer periods of time due to prolonged half-life. Therefore the drug dose must be adjusted individually. The purpose of this study was to study the fundamental pharmacokinetics of methadone in dogs, and to find an optimal drug dosage.

Today when new and harder demands on CO2 emissions are developed, vehicle manufacturers must work to develop new engine solutions to new kinds of fuels to replace fossil fuels. A fuel that could be applied is hydrogen. When hydrogen is combusted only water vapor occurs. Hydrogen is known to be explosive and flammable. These properties are both good and bad for combustion.

Blast furnace is the heart of every steel plant. Steel production is based on the blast furnace process, as it is where the iron is extracted from the iron ore and turned into liquid iron, which will subsequently be used to make liquid steel. Therefore, without hot iron, steel can not be produced. Blast furnaces in this process are supplied among others with pulverized coal. Raw coal should be prepared for the blast furnaces in the form of fine coal powder.

Blood-borne infectious diseases such as Human Immunodeficiency Virus (HIV)and Hepatitis C Virus (HCV) spread when the addicts share needles and injecting equipmentwithin contact networks. A quantitative cross-sectional study was conducted in Winnipeg,Canada in December 2003 - September 2004. Through a special questionnaire, respondentswere asked to answer questions about themselves and about their contacts, about relationshipsand how they shared syringes and other injection supplies. Blood tests were used to identifywhether they carried any blood-borne infectious diseases. We selected some variables from theoriginal data set.

Blood-borne infectious diseases such as Human Immunodeficiency Virus (HIV)and Hepatitis C Virus (HCV) spread when the addicts share needles and injecting equipmentwithin contact networks. A quantitative cross-sectional study was conducted in Winnipeg,Canada in December 2003 - September 2004. Through a special questionnaire, respondentswere asked to answer questions about themselves and about their contacts, about relationshipsand how they shared syringes and other injection supplies. Blood tests were used to identifywhether they carried any blood-borne infectious diseases. We selected some variables from theoriginal data set.